DESCRIPTION
Anjeka 7422 is a silicone surfactant for aqueous coatings, printing inks and overprint varnishes with strong reduction of surface tension and significantly improvement substrate wetting.
PRODUCT DATA
Composition: Solution of polyether-modified polydimethylsiloxane.
Tropical properties
The values given in this data sheet describe the typical properties and do not constitute specification limits.
| Appearance | Transparent liquid |
| Active matter content: | 97 |
| Density g/cm³(23℃): | 0.94-1.04 |
| Viscosity cps(25℃) | 20-150 |
| Solvents: | isopropanol |
| Flash point: | 81 °C |
STORAGE and TRANSPORT
Separation and turbidity may occur at temperatures below 5℃. Warming to 20℃ and mix well before use.Storage is not recommended for more than 12 months.
SPECIAL NOTES
Anjeka 7422 is stable in coating system of pH 4-10. In order to avoid turbidity, the additive requires a small amount of co-solvent in the formulation (approx. 5% of the total solvent content). The effective of Anjeka 7412 is reduced in systems with high co-solvent amounts. In this case, we recommend Anjeka 7333.
APPLICATION GUIDELINES
Industrial Coatings
Properties and Benefits:
This additive enhances leveling and substrate wetting by significantly lowering the surface tension of aqueous systems. It minimally affects foam stabilization or has no effect at all, preserves recoatability, and exhibits excellent wetting properties for white carbon blacks. There is no increase in surface slip, but for enhanced slip, the use of Anjeka 7333 is suggested.
Usages and Application Areas:
This additive is recommended for incorporation into all aqueous coatings, printing inks, and overprint varnishes, and it necessitates the addition of a small quantity of co-solvent.
RECOMMENDED LEVELS
0.05-0.5% additive (as supplied) based upon total formulation
The above recommended levels can be used for orientation. Optimal levels are determined through a series of laboratory tests.
PROCESSING INSTRUCTIOS
The additive can be incorporated during any stage of the production process. We recommend that the additive is added in the final production stage of coating.
PACKAGING
25KG iron drum
180KG plastic drum
Our service:
| 1. Reply within 24 hours. |
| 2. High-quality products and reasonable price |
| 3.R&D technology support. |
| 4. Professional team service |
| 5. Customiszed production for different package |
| 6. No delay on shipment |
Our team:
Our company:
We are building a new large-scale production base
strategically located in Hubei Province,with annual production capacity of 6000 tonnes of Interface additives project settled in Songzi chemical park in November 2022.
Benefits to our customers and collaboration partners:
• stable large-scale production, better quality control
• lower production unit cost
Collaboration Opportunities:
• contract manufacturing and OEM/ODM collaboration opportunities
Our Certifcate&Patents
