Wetting and dispersing additives Anjeka6910 Stabilising inorganic pigment titanium dioxide
GENERAL DESCRIPTION
Anjeka-6910 is a wetting and dispersing additive for unsaturated polyester and epoxy systems. It stabilises inorganic pigments, especially titanium dioxide, and significantly reduces the viscosity and improves the flow of the mixture.
Product Information/Product Data
Chemical composition: Copolymer mixture of acid groups, solvent free.
Typical Physical and Chemical Data:
The data given on this data sheet are typical values and are not product specifications.
Appearance | Yellow fluid |
Acid Value (mgKOH/g) | 150-250 |
Density g/cm³ (23°C) | 1.13-1.23 |
Viscosity cps (25℃) | 250-450 |
Non-volatile %: | 98 |
STORAGE and TRANSPORT
Delamination or turbidity may occur when the temperature is lower than 10℃, it can be recovered by heating to 30℃-40℃.
Storage time is not recommended to exceed 12 months.
APPLICATION SECTORS
This additive is recommended for solvent-borne and solvent-free systems to stabilise inorganic pigments, especially titanium dioxide. It effectively reduces the viscosity of the system and improves the fluidity of the system.
RECOMMENDED LEVELS
Dosage: (W/W) based on inorganic filler or pigment 0.5%-1%.
The above data are empirical, the optimum dosage should be determined through a series of tests.
PROCESSING INSTRUCTIONS
For best performance, add the dispersant to the resin first and mix well before adding the filler or pigment.
Packaging
-25kg iron drum with inner coating
-200kg ring plastic drum